Will the washer fit the laundry opening?

Enter outside dimensions from the exact washer model and clear opening dimensions measured at the narrowest point.

How this check works

Physical width, depth and height are checked independently; hose, drain, rear vibration and side/top service space are entered from the current manual.

The calculator starts with a labeled illustrative setup, not a named product. Replace the sample dimensions with measured values before relying on the result.

Example setup. Values are illustrative examples, not defaults for a product, manufacturer or local building standard. Replace them with measured dimensions.

Compare measured appliance dimensions with a cabinet or alcove and separately enter manual-based installation margins.

Length entries accept mm, cm, m, inches or feet. Weight fields are in kg. Check the exact product manual for model-dependent requirements.

Fits

Fits. Tightest constraint: appliance and side installation space. Physical space remaining: 5.0 cm 0 ft 2 in. After your selected target: 5.0 cm 0 ft 2 in.

Fits5.0 cm 0 ft 2 in after targetView details ↑

Compare measured appliance dimensions with a cabinet or alcove and separately enter manual-based installation margins.

        DimensionRequiredTargetAvailablePhysical marginTarget margin
        appliance and side installation space60.0 cm 2 ft 0 in60.0 cm 2 ft 0 in65.0 cm 2 ft 2 in+5.0 cm 0 ft 2 in+5.0 cm 0 ft 2 in
        appliance and rear/service installation space65.0 cm 2 ft 2 in65.0 cm 2 ft 2 in70.0 cm 2 ft 4 in+5.0 cm 0 ft 2 in+5.0 cm 0 ft 2 in
        appliance and top installation space85.0 cm 2 ft 9 in85.0 cm 2 ft 9 in90.0 cm 2 ft 11 in+5.0 cm 0 ft 2 in+5.0 cm 0 ft 2 in

        Assumptions

        • Opening values are clear usable interior dimensions, not outside cabinet dimensions.
        • Installation clearances are user-entered from the exact model manual. Zero means no extra installation margin was included; Fitwise supplies no default safety or ventilation minimum.
        • This mode does not model hoses, plugs, doors, packaging or delivery route.

        Scope and limitations

        • The tool does not claim a generic vibration gap, ventilation minimum or code clearance.
        • Door swing, hookup projection and delivery route are not simulated.

        Sources and entered data

        • Fitwise internal reference-size and clearance convention — Fitwise.stream

        Calculation methodology · Measurement conventions · About and data sources