Will the outdoor kitchen and work zone fit?

Measure the full run, patio and service clearances for the exact modules and appliances.

How this check works

The hard kitchen footprint is separated from side service, rear service and front work targets.

The calculator starts with a labeled illustrative setup, not a named product. Replace the sample dimensions with measured values before relying on the result.

Example setup. Values are illustrative examples, not defaults for a product, manufacturer or local building standard. Replace them with measured dimensions.

Check the measured kitchen run and user/manual-selected working and service spaces against a patio.

Length entries accept mm, cm, m, inches or feet. Weight fields are in kg. Check the exact product manual for model-dependent requirements.

Fits

Fits. Tightest constraint: kitchen run and side service space. Physical space remaining: 160.0 cm 5 ft 3 in. After your selected target: 100.0 cm 3 ft 3 in.

Fits100.0 cm 3 ft 3 in after targetView details ↑

Check the measured kitchen run and user/manual-selected working and service spaces against a patio.

        DimensionRequiredTargetAvailablePhysical marginTarget margin
        kitchen run and side service space240.0 cm 7 ft 10 in300.0 cm 9 ft 10 in400.0 cm 13 ft 1 in+160.0 cm 5 ft 3 in+100.0 cm 3 ft 3 in
        kitchen run and working/service depth70.0 cm 2 ft 4 in170.0 cm 5 ft 7 in400.0 cm 13 ft 1 in+330.0 cm 10 ft 10 in+230.0 cm 7 ft 7 in
        kitchen run height in clear overhead space95.0 cm 3 ft 1 in95.0 cm 3 ft 1 in300.0 cm 9 ft 10 in+205.0 cm 6 ft 9 in+205.0 cm 6 ft 9 in

        Assumptions

        • Service and work zones are user-entered or copied from the exact appliance/module manuals.
        • Gas, electrical, heat, fire separation, ventilation, drainage and structural support are not assessed.
        • No universal outdoor-kitchen working clearance is supplied.

        Scope and limitations

        • Gas, electric, heat/fire separation, ventilation, drainage and structural support are not checked.
        • Manufacturer and local requirements must be verified separately.

        Sources and entered data

        • Fitwise internal reference-size and clearance convention — Fitwise.stream

        Calculation methodology · Measurement conventions · About and data sources