Will the appliance fit its opening and installation space?

Use the appliance outside dimensions and clear interior opening. Enter side, rear and top margins from the exact installation manual; zero means the installation margin was not included.

How this check works

Hard width/depth/height fit is calculated first. Manual-required side, rear and top allowances are then shown as target dimensions and target margins.

The calculator starts with a labeled illustrative setup, not a named product. Replace the sample dimensions with measured values before relying on the result.

Example setup. Values are illustrative examples, not defaults for a product, manufacturer or local building standard. Replace them with measured dimensions.

Compare measured appliance dimensions with a cabinet or alcove and separately enter manual-based installation margins.

Length entries accept mm, cm, m, inches or feet. Weight fields are in kg. Check the exact product manual for model-dependent requirements.

Fits

Fits. Tightest constraint: appliance and side installation space. Physical space remaining: 5.0 cm 0 ft 2 in. After your selected target: 5.0 cm 0 ft 2 in.

Fits5.0 cm 0 ft 2 in after targetView details ↑

Compare measured appliance dimensions with a cabinet or alcove and separately enter manual-based installation margins.

        DimensionRequiredTargetAvailablePhysical marginTarget margin
        appliance and side installation space60.0 cm 2 ft 0 in60.0 cm 2 ft 0 in65.0 cm 2 ft 2 in+5.0 cm 0 ft 2 in+5.0 cm 0 ft 2 in
        appliance and rear/service installation space65.0 cm 2 ft 2 in65.0 cm 2 ft 2 in70.0 cm 2 ft 4 in+5.0 cm 0 ft 2 in+5.0 cm 0 ft 2 in
        appliance and top installation space85.0 cm 2 ft 9 in85.0 cm 2 ft 9 in90.0 cm 2 ft 11 in+5.0 cm 0 ft 2 in+5.0 cm 0 ft 2 in

        Assumptions

        • Opening values are clear usable interior dimensions, not outside cabinet dimensions.
        • Installation clearances are user-entered from the exact model manual. Zero means no extra installation margin was included; Fitwise supplies no default safety or ventilation minimum.
        • This mode does not model hoses, plugs, doors, packaging or delivery route.

        Scope and limitations

        • The calculator does not include hoses, plug bends, door swing, packaging or delivery route.
        • No generic ventilation or service allowance is asserted.

        Sources and entered data

        • Fitwise internal reference-size and clearance convention — Fitwise.stream

        Calculation methodology · Measurement conventions · About and data sources